PWA120 Adapter Plate for 1.5” Post Accessories
Chapter 2: Installation
Rev A June 2021
Page 7
2.6.
Installing Two 1.5” Posts and a Shelf
Breadboard frames with a length or width of 900 mm or 1200 mm are compatible with the overhead shelves
(PSY221, PSY223, PSY222 and PSY224). This configuration requires 2 posts and 2 adapters.
Caution:
To avoid a risk of tipping the frame…
Do not push/pull laterally on the posts as this may cause the table frame to tip over.
High loads should be placed on a shelf in a lower position, otherwise the stability of the frame could be affected.
The center-of-mass of the experimental setup as a whole, should remain within the frame area.
Do not exceed the vertical load capacity of 40 kg (88 lbs) for each adapter plate.
1. Following the procedure detailed in sections 2.2 to 2.4,
fit the
adapters in the orientation shown below, i.e. on
opposite frame legs, facing away from each other.
2. Using the central hole, fit one post to each adapter plate as detailed in section 2.5.
3. Fit the shelf to the posts in accordance with the instructions supplied with the shelf.
Figure 5 Installation – Two 1.5” Posts