THORLABS LM14S2, Руководство пользователя

Страница: 7 / 22

Butterfly Laser Diode Mount Chapter 4: Setup
Rev E, May 8, 2018 Page 5
f. Install the four 2-56 cap head screws into the four mounting holes on the butterfly package,
securing the laser to the mount.
g. Swing the pin clamps back onto the ZIF socket, taking care that all of the laser diode pins are still
aligned onto the correct contacts.
h. Press the latching mechanism forward onto the pin clamps until they snap into place, latching the
pin clamps onto the pins and contacts.
4.2. Configuration Cards
The LM14S2 is shipped with two configuration cards needed to program the unit for the proper pin-outs for the
type of laser being installed in the mount. In most cases, the dual Type 1 / Type 2 Configuration Card can be used
to route the DB9 input signals to the mounted laser diode. Refer to Section 4.2.1 for specifics on which side of the
configuration card to use.
For non-standard devices that do not use the pin-out conventions described on the next page, we have included a
custom configuration card. This card is designed to allow you to easily configure the mount to any pin
configuration by soldering wires between the appropriate points on the card. For convenience, the outline of the
butterfly package is shown on both sides of the card, in its proper top and bottom views. In addition, an extra set
of holes is provided to allow multiple connections to one node.
Ideally a solid 26 – 30 AWG insulated wire can be used for the various connections, but any suitable wire can be
used.
Refer to Tables Table 1 and Table 2 for signal nomenclatures shown in bold type.
Figure 2 Custom Configuration Card