ELL9K Four-Position Slider Evaluation Kit
Chapter 4: Operation
Rev. C, Feb 2020
Page 7
4.2.1 Hand-held Controller
Caution
On power up the stage will move while the unit checks the sensors and then searches for the home position.
The ELL9K Evaluation Kit also contains a hand-held controller, which features two buttons (marked FW and BW) that allow
switching of the optic position as explained below. The handset also provides for connection to the host PC and to the external
5V power supply. This allows the stage to be used in the absence of a PC, with control being achieved via the handset
buttons.
LED1 (green) is lit when power is applied to the unit. LED2 (red) is lit when the device being driven is in motion.
Figure 5 Handset details
Using the hand-held controller and referencing Figure 1 and Figure 5:
1.
Connect the hand-held controller to the stage unit.
2.
Connect the hand-held controller to the 5V Power Supply and switch on.
3.
Wait while the stage powers up and goes through its homing sequence.
4.
To increment the position of the slider, press and hold JOG then press FW.
The switching time between positions is <500 ms no load and <700 ms with 150g load.
5.
To decrement the position of the slider, press and hold JOG then press BW.
6.
To Home the stage (i.e. go to position 0) press the BW button.
Содержание ELL9
Страница 22: ...www thorlabs com ...
