THORLABS CLD101 Series, Руководство по эксплуатации

Страница: 24 / 92

© 2018 Thorlabs 22
CLD101x
2.5.4 Laser Driver Setup
Laser Driver Setup - CLD1010LP and CLD1015 Laser Driver Setup - CLD1011LP
Use the arrow buttons to select a parameter, then push EDIT button, or push the selected topic a
second time.
·
Laser Current Limit : Set the current limit to prevent damage of the laser diode.
·
Operating mode : Select Constant Current or Constant Power mode. For details, please see
the Appendix .
·
Noise reduction filter : Enabling this filter reduces the output current noise by a factor of ~ 2.
Along with that, the modulation bandwidth reduces to 7.5 kHz, see Specifications . The filter
can be enabled / disabled only with the laser switched off.
·
Enable Modulation Input : Checking this box, the signal applied to the SMA connector (4) on
the rear panel modulates the laser.
·
Switch Laser on when starting device : Default setting is "Laser OFF" when starting the
CLD101x . If required, the laser switched-on state can be changed.
2.5.5 Laser Protection
Use the arrow buttons to select a
parameter, then push EDIT button, or
push the selected topic a second time.
77
68
7