Never switch on the amplifier until all tubes have been placed into their respective
sockets.
Always remove all tubes from their sockets and put them in their original transport
box before shipping or transporting the amplifier.
4. Bring the amplifier into its final position on the rack, shelf or platform.
5. Connect the speakers to the amplifier.
6. Connect the inputs of the amplifier to the desired (line-level) program sources or/and
to a line or full function preamplifier. If a preamplifier of either type is to be used, it is
advisable to control the volume and the balance on the preamplifier and to set the volume
knobs of the integrated amp (which serve as attenuators) at about half of the maximum
rotation angle. The volume should be turned to zero on the preamplifier.
7. If the volume knobs of the integrated amp itself are to be used for controling the
volume (and the channel balance) these knobs should be set to zero.
In both cases the slots surrounding the volume knobs on the Stereo Integrated may serve
as a scale to attain precise channel balance.
Do not switch on the amplifier until it has been properly connected to the speakers,
the program sources and/or an eventual external line or full function preamplifier.
8. Power on all program sources and preamplifiers that are to be used for listening.
Always switch on the program source(s) and eventual preamplifiers in the system
first, and then switch on the Integrated Amp with a delay of not less than one
minute !
9. After a delay of about one minute, the Integrated Amp can be connected to the mains
and switched on.
10. Select the desired program source with the source dial located at the back of the
amplifier, adjust the volume for convenient loudness, correct channel balance and enjoy
the music.
When powering off the system, always switch off the integrated amplifier first, then
switch off the program sources and eventual preamplifiers observing a delay of not
less than 30 seconds.
Never switch a program source or the preamplifier on or off while the power
amplifier is powered on.
When powering off the system, always switch off the power amplifier(s) first, then
switch off the line and phono preamplifiers observing a delay of not less than 30
seconds.
