November 30th 2018
www.thonk.co.uk
13
God’s Box Lollipop
Eurorack DIY Kit
Instructions
Version 1
27.
The module looks much nicer when
the LED bar is soldered flush to the
front panel. Secure the panel by
screwing a few nuts and washers
onto the pots, then make sure the
LED bar is lined up straight to the
panel hole.
It’s a good idea to solder a single
edge pin of each row and then check
that it’s still lined up straight before
proceeding with the rest of the solder
joints – this way you can still re-
position it if required.
28.
Now add a few nuts to the jacks and
switch to hold the panel in place and
then solder in all the pots, jacks and
switches.
29.
Now remove the panel and fit all the
ICs into their sockets as shown
NOTE!
Orientation is vital for all ICs
For the seven TL072 make sure the
black circle on the top face of the IC
is facing the end with the notch in the
IC socket as pictured.
For all other chips make sure the
notch in the chip is at the side with
the notch in the IC socket.
TL074
TL072 TL072
TL072
LM3914
DG419
