AT-AT-AT
Eurorack DIY Kit Instructions
Page 5
5.
Check the components are sitting flush
between the panel and PCB, and then
flip the module over and solder all the
pins for the pots and jacks on the back of
the PCB.
6.
Finally attach the knobs onto the pots
and the three red jumpers onto the
headers on the back of the PCB.
Before attaching the knobs, be sure to
turn the pots fully counterclockwise and
line the knob pointer with the notch on
the panel before pushing on firmly.
Place the red jumpers in the LIN position
as shown if you’re attenuating CV
signals, or the LOG position if you’re
mainly attenuating audio signals.
7.
The module is now complete and ready
to mount in the rack (this module doesn’t
require any power).
April 2022
Version 2.0
