connecTionS
P7
En
g
lis
h
2.5 installing the batteries
Fig. 4
Remove the battery cover from the remote control and put 2x AAA size batteries inside the
compartment.
The diagram inside the battery compartment shows the correct way to install the batteries.
1. Open the cover
2. Install batteries
3. Close the cover
noTe:
The batteries should not be recharged, disassembled, electrically short-
circuited, be mixed or used with other types of batteries.
2.6 Using the remote control
Fig. 5
To use the remote control, point it towards the front of the digital receiver. The remote control
has a range of up to 7 metres from the receiver, if properly aligned towards the IR eye on the front
panel.
The remote control will not operate if its path is blocked.
noTe:
Sunlight or very bright light might decrease the sensitivity of the remote control.
3.0 connecTionS
For basic setup with 1 dish + 1 LNB: Connect the satellite cable to the SAT IN connector on your
receiver. For advanced dish setup, refer to section
3.3
3.1 Basic connection using an HDMi cable
Fig. 6
1. Connect the LNB of your satellite antenna to the SAT IN connector of your receiver using a
good quality coax cable and suitable ‘F-connector’ plugs.
2. Connect one end of a good quality HDMI cable to the HDMI output on your receiver and the
other end to the HDMI input of your TV.
3. Plug the power adapter to a suitable wall outlet.
3.2 Basic connection using a Scart cable
Fig. 7
1. Connect the LNB of your satellite antenna to the SAT IN connector of your receiver using a
good quality coax cable and suitable ‘F-connector’ plugs.
2. Connect one end of a good quality Scart cable to the TV SCART connector on your receiver
and the other end to the SCART input of your TV.
3. Plug the power adapter to a suitable wall outlet.