THOMSON TG185n, Руководство по установке и эксплуатации

Страница: 39 / 96

E-DOC-CTC-20080624-0009 v0.2 33
5 Your THOMSON TG185n as Wireless Client
5.2 Manual Configuration (Without WPS)
Procedure
Before you can use your THOMSON TG185n as a repeater you have to complete following steps:
1 Switch the THOMSON TG185n to wireless client mode .
2 Assign a static IP address to your computer .
3 Connect the THOMSON TG185n to your access point .
4 Configure the IP settings of your THOMSON TG185n .
5 Configure your computer to obtain an IP address automatically .
Switch the THOMSON TG185n to wireless client mode
Proceed as follows:
1 On the back panel of your THOMSON TG185n, move the switch to the client position.
2 After a few seconds the Client LED will turn green.
Assign a static IP address to your computer
The IP address must be between 192.168.1.14 and 192.168.1.252. The subnet mask must be 255.255.255.0 .
For more information, see “7.1 Assigning a Static IP to Your Computer” on page 44 .
Connect the THOMSON TG185n to your access point
Proceed as follows:
1 Open your web browser and browse to http://192.168.1.12 .
2 The THOMSON TG185n Web Interface appears. On the Device Status menu, click Site Survey .
3 The THOMSON TG185n lists all the access points that are within range.
4 Select your access point and click Associate .
5 If your access point is secured, the THOMSON TG185n will take you to the Wireless Settings page. Enter
the passphrase/key used by your access point and click Apply .
6 The THOMSON TG185n prompts you that the configuration was successful.