18
3. Press UP and DOWN to select
TONE
or
PULSE
then press MENU to confirm.
Changing the flash time
1. Press MENU, then DOWN to select
SETUP
and press MENU.
2. Press DOWN to select
FLASH TIME
.
3. Press UP and DOWN button to select the new flash time. (Setting 1 = SHORT; Setting 2 = LONG)
4. Press MENU to confirm.
Restoring factory settings
You can restore the factory settings for the telephone base at any time.
1. Press MENU, then DOWN to select
SETUP
and press MENU.
2. Press DOWN to select
DEFAULT
and press MENU.
3. Enter the 4-digit PIN
code (default PIN is “0000”) and press MENU.
4. The screen displays
CONFIRM?
Press MENU to confirm or
to return to the previous menu.
The phone automatically switches off and then turns on again. The default settings are restored.
Resetting the telephone in case of emergency
If you have lost your PIN, you can restore the default settings as described below:
1. Remove and replace the handset batteries.
2. Press and hold the key while reinserting the batteries.
3. Display shows
DEFAULT
. Press MENU.
Eco mode
This feature saves power consumption and reduces radio waves emission.
The indoor and outdoor operating ranges will be reduced in eco mode.
You may access the Eco Mode via
MENU
>
SETTINGS
>
ECO MODE
.
Registering handsets to telephone bases
Registering a handset
The supplied handset is by default registered to the telephone base. You can register up to 5 handsets to a
base.
1. On the telephone base: Press and hold
for about 3 seconds. When you hear two beeps, the
telephone base is switched to registration mode. You have 90 seconds to register a handset.
2. On the handset: Press MENU, then DOWN to select
REGISTER
and press MENU.
3. Press DOWN to select
REG BASE
and press MENU.
4. Enter the telephone base number (1-4). If the number flashes, that means it is already in use.
5. When the handset looks for the signal from the telephone base, the screen displays
SEARCHING
and
the identification number of the telephone base.
6.
The screen will prompt you to enter the PIN code. Key in the PIN (default is “0000”) and press MENU to
confirm. A confirmation tone sounds and the handset is now registered.
If the telephone base cannot be found after a few seconds, the handset returns to standby mode. Try to
register again.
When the handset is registered to the telephone base, a number is automatically assigned to it.
The number is displayed on the screen and will be used for internal calls.
If registration does not work:
