- EN 7 -
4.
“Alarm 1 (or 2) Setup” is displayed. Press the
ENTER
button to select.
5.
“Alarm 1 (or 2) Wizard On time” is displayed and the hour digits for the alarm will flash.
6. Press
/
repeatedly to set the hour. Press
ENTER
to confirm.
7. Press
/
to set the minutes. Press
ENTER
to confirm.
8. Press
/
to select the Alarm volume from 0 to 30. Press
ENTER
to confirm.
9. Press
/
to scroll to OFF/CD/DAB/FM/USB/BUZZER status. Press
ENTER
to confirm.
10.
Press the
/
button to scroll to the alarm duration. You can choose from 15, 30, 45 and 60
minutes. Press the
ENTER
button to select. Press
/
to select YES and press
ENTER
to
save the alarm.
11.
The display will show the current time and Alarm 1 (or Alarm 2).
Snooze
1.
Whenever the alarm (alarm 1, alarm 2) comes on, it can be temporarily suspended for a short
period of approximately 9 minutes, by pressing the “
SNOOZE
” button once.
2.
The alarm (alarm 1, alarm 2) will then automatically come on again after the 9-minute “snooze”
period has ended.
3.
And the “snooze” symbol will show on the display to remind you that the snooze function is active.
4.
To deactivate the snooze, press and release the “
POWER
” key once.
Sleep Timer
1.
Repeatedly press the
SLEEP
button; you can set 90/80/70/60/50/40/30/20/10 minutes. This is
useful for falling asleep to music at night.
2.
If you want to cancel the sleep mode, repeatedly press
SLEEP
to select OFF; the sleep mode will
cancel.
FM Radio
Carefully extend the telescopic aerial to its full length. You can program a maximum of
30 preset radio
stations (FM)
Auto Scan
1.
Rotate the
SOURCE
key to select “RADIO” mode.
2.
Long press the
button, and your radio will scan and stop automatically when it finds a
station of sufficient signal strength (30 stations preset).
3.
After a few seconds, the display will update. The display will show the station frequency.
4. Press
MEM
to view the preset radio stations
5. Press
MEM+
or
MEM-
to view or listen to the stored radio stations.
6.
To find other stations, press and hold the
button as before.
7.
To scan the FM band in the opposite direction (high frequencies to low frequencies), press the
button and hold for 2 seconds.
Manual Scan
1.
Rotate the
SOURCE
key on the main unit to select “RADIO’’ mode.
2. Press
or
to tune to a station. Each press on the tuning button will change the
frequency up or down by 100 kHz.
3.
Once you find a station you want to save, press the
MEM
button on the remote control. “P01”
will be shown on the display; press
MEM+/MEM-
until the desired memory position number
appears on the display. Press the MEM again to confirm and save the current station.
4. Press
MEM+
or
MEM-
to view or listen to the stored radio station.
(Note: When the waveband end is reached, the radio will recommence tuning from the opposite
waveband end. If no stations are found, please ensure the aerial is extended and test the reception by
doing another auto scan in a different location.)
