THOMSON Grass Valley KAM-HD-MULTI, Инструкция по эксплуатации

Страница: 47 / 102

KAM-HD-MULTI—Instruction Manual 47
Kameleon HD Links and Web Pages
System Config Web Page
Use
this
link
The System Config web page ( Figure 25 on page 48 ) provides the following
system configuration controls:
• Selection of the SD or HD input video type and rate for the module.
• Enabling or disabling all HD and SD video processing, including color
correction or enable a color bars output test signal.
• Selection of an output timing source.
• Enabling or disabling of the split screen function and screen position for
comparing the input video to the processed video. This function is also
on the HD and SD Video Proc and Color Correction web pages.
Input Video
Select the desired video input type and rate from the
Input Type
radio buttons
and
Input Rate
pulldowns. Refer to Table 4 on page 25 for a complete list of
available input types and rates.
Note Pressing the Defaults button or changing the Input Type from HD to SD on
the System Config web page or with an E-MEM recall will cause the module
to reboot. It will take approximately 30 seconds to re-initialize. During this
time a Wait Page (
Figure 24 ) will appear. Wait for the operation to complete
then select the Refresh button to update the web page.
Figure 24. Wait Page
Refresh button