8900NET Instruction Manual
33
Using the 8900NET GUI
SNMP Report Activation
Each report destination has an activation control that can select one of the
following modes of operation:
•
CREATE – GO
creates a new report destination that becomes active after
the next module reboot.
•
CREATE – WAIT
creates a new report destination that remains out of
service until the user selects active and then reboots the module.
•
ACTIVE
changes a
NOT IN SERVICE
report destination to active after the next
module reboot.
•
NOT IN SERVICE
changes an active report destination to inactive after the
next module reboot.
•
DELETE
removes the report destination entry. If the entry was active it
remains active until the next module reboot.
Note
Report destination status does not change until the 8900NET module is
rebooted.
The status column to the left of the activation operation pull-down window
provides one of the following status reports:
•
<BLANK> –
No entry has been applied.
•
ACTIVE
– All new status reports will be sent to this destination.
•
NOT IN SERVICE
– The destination has a valid definition but the user has
not activated it.
•
ACTIVE PENDING REBOOT –
This entry indicates the report destination will
become active upon the next module reboot.
•
NOT IN SERVICE PENDING REBOOT
– This entry indicates the report destina-
tion will become inactive upon the next module reboot.
•
NOT READY
– The destination entry is invalid. The IP Address may not be
properly defined or there is no IP Address or Community entry.
