14
General Product Care
Simply wipe the base station with a damp cloth or an antistatic wipe.
Never use a dry cloth as this can cause static discharge.
Troubleshooting Guide
When you forget base PIN, following the procedure to reset the units.
ALL MEMORY AND SETTING WILL BE LOST.
z
Disconnect the line cord and AC power supply.
z
Hold “Page” button and plug in the AC power supply (in-use
LED will be on).
z
Release “Page” button after hear two beep tones and press it two
times again.
z
The In-Use LED will turn off.
z
Wait for few seconds, disconnect AC power supply and plug in
again.
z
The unit will return to its default setting a PIN code (0000).
z
Following "Registering Additional Handsets" to register all
handsets again.
PROBLEMS CAUSES SOLUTIONS
Registration not
work.
The battery is not
sufficiently
charged.
Handset and base
station were not
prepared for
registration.
Charge the battery for
14 hours (see Battery
Charging).
Unplug and then plug
in the power adaptor.
No display.
The battery has not
been charged.
Charge the battery or
replace them (see
Battery Charging)
No reactions to
keystroke.
No radio connection
to the base station:
blinking!
The keypad is
locked.
The handset is
outside the base
station range.
The handset is not
registered.
The base station
does not work.
Press
#
key longer
than 2 seconds.
Move closer to the
base station.
Register the handset
(see Registering
Handset).
Unplug and then plug
the power adaptor to
the power outlet
(220-230V AC / 50
Hz) and the other end
into the power jack on
base bottom.
Environment
Used equipment and used handset batteries must be disposed of in
compliance with current environmental protection regulations. You
should return them to your reseller or dispose of them at an approved
recycling centre.
Do not attempt to open the batteries, as they contain chemical
substance. In the event of leakage, avoid contact with the skin, eyes
and mouth. In the event of contact, rinse the affected part for several
minutes in running water. Clean the product with absorbent paper or
a dry cloth and contact your reseller for replacement batteries.
