THOMSON DTI 1004, Руководство пользователя

Страница: 12 / 13

Annexes
10
7. Trouble shooting
If the receiver does not work properly after checking the trouble shooting section, please contact the
dealer.
Warning : never open your set yourself.
Symptoms Cause Solution
The green/red lights on front
panel do not light up. The power cord is not
plugged in. Check that the power cord is plugged
into the wall outlet.
No picture and sound. TV is set to wrong channel. Check if the TV is switched on and set
your TV to the correct EXT / AV or
UHF channel.
No picture and sound.
No picture and sound.
No picture and sound.
The receiver displays the
message “
no signal ”
during bad weather conditions
heavy rain or snow).
This is normal, the bad
weather is interfering with
the signal. Once the weather is better the
picture will appear. If not check your
antenna or call your dealer.
The receiver or TV is in
“mute”’ mode. Press the MUTE key on the remote
control of your receiver and/or TV.
Receiver “hang-up”. Switch off receiver; disconnect the main power
cord of the receiver from the 230V mains.After
30 seconds reconnect to the main power and
check if it is working properly.
Problem in cable connections
between receiver and TV. Check if the scart and/or RF cable is connected
correctly to the TV and to the back of the
receiver. Replace the scart cable
The receiver displays the
message “
no signal ”.
Wrong reception. Check your connections.
The receiver displays the
message “
no signal ”.
Wrong parameters set in the
menu. Check settings in antenna and channel
set up menu.
The remote control is not
working. The batteries of the remote control
are not inserted or exhausted. Check the batteries.
The remote control is not
working. Receiver is in very low power
standby. Press the Standby button on the receiver.
The receiver displays the
message “
no signal ”.
For the DTI 1004 - First installation
failure. Antenna. If you use an indoor antenna requiring a
specific powering by RF cord, please switch
the value to
On in the installation menu
(see MENU / Installation / Terminal / Antenna )
and restart the installation by MENU /
Installation / Channels .
Wrong alignment of the antenna. Ask your dealer to check the outdoor
antenna unit and antenna cable.
For the DTI 652 - The menu is in a
language I don’t understand. The menu language has been changed
without you knowing it. To change the menu language, follow the steps
described below:
1. Press the
MENU
button.
2. Press 3 times the
q
button.
3. Press 3 times
OK
.
4. Use the
t
/
u
buttons to select your
preferred menu language. The menu language
has now been changed.
01_DTI652_1004_en.indd 10 01_DTI652_1004_en.indd 10 11/05/06 19:39:43 11/05/06 19:39:43