THOMSON DTH-8560, Руководство пользователя

Страница: 45 / 52

II
Programming the remote control
If your remote control does not control your satellite receiver (or cable) or your television set you will
need to configure it using one of the two methods proposed: automatic code search or manual
programming.
Automatic code search
This method can be used to automatically find the
most appropriate code for your appliance.
1. Switch on the appliance you wish to use the
remote control with.
2. Press the relevant button for this appliance on
the remote control, and while holding this
button down, press the
B B
standby button until
the remote control light comes on. Release the
two buttons.
3. Point the remote control at the appliance and
press PLAY.Wait until the light stops flashing.
If the appliance has not gone into standby
mode after five seconds, press the PLAY
button again to continue the search for the
next set of codes. Repeat this operation until
the appliance goes into standby mode.There
are 20 sets of codes
4. When the device changes to standby, press the
standby button
B B
on the front to switch it
back on again.Then press the REV key to set
it to standby again and, if necessary, retry until
the device changes to standby.
5. Press the STOP button and hold it down until
the remote control light goes off.
Manual programming
This method involves carrying out a manual
search for the codes to be used for controlling
your other appliances.
1. Switch on the appliance you wish to use the
remote control with.
2. Press the corresponding key on the remote
control, while holding it pressed down, enter
one of the codes corresponding to the make of
the device.
If the remote control light flashes you have entered
the wrong code or it is not possible to program the
remote control.
3. Point the remote control at the appliance and
press the relevant button. Press the
B B
. If the
appliance does not go into standby mode, try
another code.
Depending on the year of manufacture and the type
of appliance, some functions may not be available.
Certain codes may cover more functions than
others.Test the functions you can control and, if
appropriate, try other codes.
Note: when you change the remote control’s
batteries , remember to reprogram it.
Remote control - Code A-B
With certain devices (combined TV/DVD or other DVD player) it may happen that your DVD
recorder controls the DVD player of the other device. In this case you can adjust your remote
control and the DVD recorder on another code known as code B.
Remote control setting on code B
Note: the remote control of your DVD recorder is set to code A
(3000). To set it to code B (3001) follow the procedure
described below.
1. Press and hold the
DVD
key.
2. With the number keys, press
3
,
0
,
0
,
1
.
3. Release the
DVD
key.
DVD recorder setting on code B
1. Switch on your DVD recorder.
2. Check that there is no disc in the disc tray.
3. Simultaneously press the
PLAY/PAUSE
,
AV
keys at the front of your DVD recorder and
release them when your DVD recorder displays
DVD B
.
4. Try to control your DVD recorder with the remote control.
Note: in the event of a problem, redo the setting of both components: the remote control and your DVD
recorder.
Code A
Code B
On display panel No. to key in
3000
3001 DVD A
DVD B
RCT615DBMLI.qxd 23/09/05 16:13 Page 4 (Noir/Process Black film)