EN
21
Advanced Sound Control
Fine Setting of the Speakers
This receiver supports a wide range of speakers and
subwoofers. For optimal surround sound enjoyment,
you need to register the speaker selection settings of
your audio system. If you buy this receiver with
accompanied speaker package, then this step has
been done for you.
Also, to make the surround sound more effective and
suit the acoustic conditions in your listening room,
you need to delay the signal from some of the speak-
ers. Such channel delay compensates for center or
surround speakers that are closer to listening position
than the front speakers. You can make use of the
SETUP
button to adjust the speakers’ relative loud-
ness.
The TEST TONE button
You can adjust the relative loudness of the individual
speakers by the
TEST TONE
button.
1. In Surround (Dolby Digital/Pro Logic/DTS) modes,
press
TEST TONE
briefly. A short noise will be heard
in the speakers one by one. The speaker having the
noise at that moment will be shown in the display.
2. To adjust the volume level of the test tone, turn
up/down the
VOLUME
knob or press
vol + / -
key on
the remote control.
3. To adjust individual speaker volume level, press the
LEVEL
button when the short noise is played on the
speaker you want to adjust then turn the
VOLUME
knob to modify the output level.
4. Press
LEVEL
again to save your setting.
5. Repeat step 3 to adjust other speaker volume lev-
els.
Advanced Setting
Factory defaulted Advance setting indication
from VFD
The receiver has defaulted the following distances:
Front speakers
(L/R)
4.5m
Center speaker
(Cch)
4.5m
Rear speaker
(SUR)
3m
Speaker Configurations
You can also change the setup of the speakers by
pressing the
SETUP
button until the display shows
L/R SML or L/R LRG which enables you to set the size
of the front speaker.
Available Selections:
Pressing
SETUP
button once, while the display is still
showing L/R LRG, you may press the
OK
button to
toggle among: front, center, surround, subwoofer,
subwoofer phase and speakers’ distance, sleep and
dimmer setup. Set the speaker size or speakers’ dis-
tance by pressing
UP/DOWN
ARROW button.
R/S
L/S
Rch
Cch
Lch
Front
Left
Rear
Right
Rear
Left
Front
Right
Center
Front Speaker selection
Large/ Small
Center Speaker selection
Large/ Small/ None
Surround Speaker selection
Large/ Small/ None
Subwoofer selection
Yes/ No
Subwoofer Phase
+ / -
Front Speaker distance
0.9-12m
Centre Speaker distance
0-12m
Rear Speaker distance
0-12m
SETUP TEST TONE
EQ
DIGITAL INPUT
ST / MONO
OK
SURR. MOD
DSP MODE
2
3
6
5
4
1
vcr/sat
tv
pr
pr
down
rep.
mix
BASS/TREBLE
VOLUME
LEVEL
E
NOTE
To adjust the level of all speakers (center and
surround speakers), you must select Pro Logic
mode first by pressing the SURROUND key
BASS/TREBLE
VOLUME
LEVEL
S/TREBLE
LEVEL
VIDEO
UX
L - AUDIO - R
