DFT-6101 Battery Resistance Tester Instruction Manual
6
Setting interface Testing interface End interface
2.2.1
(Optional): Test instructions with connection resistors (same Test in Strings)
3-wire & 3-clamp simultaneous Test. The red clamp is connected to the connection resistor, the red and black
clamp is connected to the end of the positive pole of the battery and the connection resistance, the black clamp is
connected to the negative electrode of the battery, click the Test, you can complete the Test of the internal
resistance and the connection resistance, and so on.
(Note that in general, the first section of the positive electrode of the electrical Test does not have a connecting
strip, you can connect the red clamp with the red and black clamp at the positive end of the battery, direct Test,
then the connection resistance value of the first section is 0)
2.3.
Battery String Test
The Battery String Test interface is as follows, and its Test operation method is similar to that of single cell Test,
but the number of battery cells is increased, and before a String of batteries is tested, it can be tested continuously
without operating the interface. Click the touch screen Start Test button to take the Test.
