Thomasville Carmel P2505, Руководство по установке

Страница: 13 / 35

Installing the Light Kit
/ Glass Shade
REMEMBER to disconnect the power.
THE GLASS IS FRAGILE, USE CARE
WHEN INSTALLING THE LIGHT KIT
AND THE GLASS SHADE.
1. Remove two of four mounting
screws and lockwashers on the switch
cup below the fan motor assembly,
loosen but do not remove the other two
mounting screws and lockwashers
(Figure 17).
2. Connect the blue and white wires
exiting the switch cup below the fan
motor assembly with the black and white
wires from the light kit assembly by
connecting the polarized plugs (blue to
black; white to white). Carefully push all
wires back into the switch cup.
3. Align the two key slots in the light
kit assembly with the two mounting
screws and lockwashers on the switch
cup that were loosened in step 1, place
the light kit assembly over the two
screws, turn the light kit assembly
clockwise until it locks, tighten the two
screws.
4. Re-install the two mounting screws
and lockwashers that were removed in
step 1 and tighten firmly.
5. Remove the finial, and then remove
the two hex nuts and one rubber washer
from the threaded tube, install the
threaded tube onto the stem of the light
kit assembly and secure with one of the
two hex nuts (Figure 17).
6. With power off, insert 2 candelabra
base bulbs into the sockets, Max. 60w
(provided).
7. Raise the glass shade up against
the light kit assembly and secure
properly with rubber washer and the hex
nut, DO NOT OVERTIGHTEN THE
HEX NUT, OVERTIGHTEN THE HEX
NUT MAY CAUSE GLASS TO
BREAK. Finally secure with the bottom
cover and the finial (Figure 17).
NOTE: ALLOW THE BULBS TO
COOL COMPLETELY BEFORE
TOUCHING OR REPLACING THE
BULBS TO AVOID ACCIDENTAL
BURNING OF THE SKIN.
10.
(provided)
WARNING:Over lamping the fan will
result in the fan lights shutting down until
the proper wattage of bulbs are installed.
Reset the lights by turning off, replace bulbs
with the correct wattage bulbs,Turn power
on.