Handle adjustment
For transportation the handles are turned over on the
underside of the walker’s top part. In order to position
them correctly, loosen the screw and turn the handles until
they face upwards (fig. 1). If possible, maintain the 90°
angle between handle and armrest (both ways horizontally
and vertically). Make sure the grid matches up.
Height adjustment of the armrest
The height of the armrests can be adjusted by loosening
the two clamp screws on either side (fig. 2). The height is
set correctly when the arms of the user are resting in a
90° angle on the arm supports.
Adjusting the brakes
The brake action can be fine adjusted by tightening the
brake cable on the hand brake. By turning the cable
tightener to the right, the brake action is reduced (fig. 3).
In addition, the brake can be adjusted at the end of the brake
cable (fig. 4) by turning the cable tightener.
Always secure the trio walker against rolling when getting
in or off! You can lock it by pushing the button on the
handbrake. To unlock again, slightly pull the brake arm of
the hand brake.
Width adjustment
If you possess a model with width adjustment, you can
change the position of the armrests. Loosen the screws
underneath the armrests (fig. 5). Adjust the desired position
and retighten the screws.
fig. 1
fig. 2
fig. 3
fig. 4
fig. 5
Attention:
After changing the position of the armrest do not forget to
tighten the clamp srews! Use at most 10 Nm for tightening
otherwise damaging could happen! Also pay attention to
the maximum possible extension position (marked on the
pipes)!
Attention:
Always make sure that the wheel can only just swivel
when the brake is released. Too much space between
wheel and brake reduces the brake action!
3
