RECARO ProSport Reha – Instructions for assembly and use (supplement)
5
5a
5b
Footrest adapter
(accessory)
item code: 821
Make sure that the seat has been pre-assembled with a metal-base plate. The
footrest adapter can only be attached to the metal plate!
If your seat does not have a metal plate, it still can be installed as an
accessory later.
Note:
The use of the recline-position is not possible if the seat is fitted with a metal
plate.
The Velcro strips (hooks) remain on the footrest adapter. Carefully remove
the plastic film from the backside of the Velcro strip (fleece), while the strip
remains velcroed to the adapter.
Place the footrest adapter on an even surface. The velcro must be on the
top side.
Take the seat with the metal plate and position the base plate as follows:
a) Adapter and base plate should lie flush at the front!
b) The seat with its metal plate is to be positioned in the center of the
adapter!
Position the seat flush in a 90° angle at the front of the adapter (handle of the
adapter facing forwards) and tilt the seat over to velcro it to the adapter.
Footrest:
The footrest is attached to the adapter.
Fig. 5a:
Attaching Velcro straps to the seat
Fig. 5b:
Attaching seat to adapter
After having connected base plate and adapter for the first time, loosen the
connection of the velcro (Hook / Fleece) again. Then press the Velcro strips
firmly to the surfaces of the base plate and the adapter for a second time to
make sure that they are sticked down safely.
Further available accessory for the footrest adapter:
• Seatfix connection (for footrest adapter) (accessory)
Item code: 818
The seatfix connection secures the adapter and prevents slipping.
Note:
Your car must have an ISOFIX fixture (at least on the rear passenger
side). Check before buying!
• Stabilizing bow, rear (for footrest adapter) (accessory)
Item code: 819
Using the stabilizing bow increases the safety of the overall seat in
combination with the adapter!
