TA02975 B page 3 of 4
4
11
12
4
6
13
22
5
200
9
8
1
23
21
27
2
3
7
16
11
15
201
17
18
19
20
FIGURE 3
The items marked with (
K
) are those Thomas & Betts
recommends replacing if the head is disassembled.
The warranty is void if parts used are not original
Thomas & Betts parts.
When ordering spare parts always specify the
following:
−
Code Number of Item
−
Name of Item
−
Type of Head
−
Head Serial Number
Code N°
Item
Description
Qty
6120126
1
CYLINDER
1
6100035
19
KEY
1
6900211
20
SCREW
1
6362035
21
SEAL
1
K
6340060
22
GRUB SCREW
1
6232590
23
TA 04567 LABEL
1
8502021
27
RB38-F QUICK COUPLER
1
6620312
200
COMPLETE RAM
1
6700250
200
2
CIRCLIP
1
6170140
200
3
COVER
1
6760040
200
4
PIN
2
6362058
200
5
SEAL
1
K
6040128
200
6
BACK-UP RING
1
K
Code N°
Item
Description
Qty
6520611
200
7
SPRING
1
6520619
200
8
SPRING
1
6300079
200
9
RAM GUIDE
1
6522006
200
11
SPRING
1
6620320
200
12
PIN
1
6620445
200
13
PIN
1
6370234
201
COMPLETE HEAD
1
6522006
201
11
SPRING
1
6620440
201
15
PIN
1
6340540
201
16
GRUB SCREW
1
6760160
201
17
PIN
1
6620460
201
18
PIN
1
4.0
PARTS LIST
for Type 2
Use an appropriate size wrench:
− Remove the obsolete coupler.
− Carefully clean the thread to remove the old sealant.
− Apply Teflon tape to the thread.
− Fit the new coupler and tighten to
15 lb ft (20 Nm)
.
The oil pressure in the head must always be completely
released before disconnecting the head from the hose.
Dust, sand and dirt are a danger for any hydraulic device.
Avoiding putting the head on muddy or dusty ground.
Any dirt particles may score the ram and create oil leaks.
Every day, after use, the tool must be cleaned with a
clean cloth, taking care to remove any residual particles,
especially close to pivots and moveable parts.
REPLACEMENT OF THE COUPLER
The head is robust and requires very little daily maintenance.
Compliance with the following points should help to maintain the optimum performance of the tool.
CLEANING
3.1
3.5
3.0
MAINTENANCE
See Figure 3 for Head Assembly.