TA02966 E page 4 of 8
6170143 27
PLASTIC CAP
6232421
26
(TA 02964) TOOL LABEL
6040427 15
STRAP ANCHOR RING
6000236 16
PRESSURE RELEASE BUTTON
6000378 17
OPERATING PUSH-BUTTON
6040427 18
STRAP ANCHOR RING
14,4V - 3,0Ah - Ni-MH BATTERY
6800040 20
RESERVOIR CAP
6720075 21
OIL RESERVOIR
6800088
22
PLASTIC CAP
6620250
23
PLASTIC CAP
6232243
25
(TG 0443) LABEL
6000310
24
MOTOR
8502001
19
1
1
1
1
1
1
1
1
1
1
1
1
2
6232006 28
(TG0356) WARNING LABEL
1
DESCRIPTION
Code N°
Item
Qty
DESCRIPTION
Code N°
Item
Qty
1
1
1
1
1
1
1
1
1
1
1
1
1
1
6000354
01
WRIST STRAP
6900211 02
M5X10 SCREW
6100035 03
KEY
6370238
04 COMPL.“C” INSULATED HEAD
6620440 05
DIE HEAD RETAINER PIN
6340540 06
M10X8 GRUB SCREW
6522006 07
SPRING
ø 3x28 ELASTIC PIN
6620245
09
DIE HEAD RELEASE PIN
6620320 10
DIE RAM RETAINER PIN
ø 3x8 ELASTIC PIN
6620445 12
DIE RAM RELEASE PIN
6522006 13
SPRING
6620312 14
COMPLETE RAM
6760160 08
6760040 11
Should it be required, top up the oil as follows (Refer to
Figure. 4, page 5):
− Remove the battery (19), place the tool in a vertical
position and remove the filler cap (20) located inside the
battery housing, fill the reservoir (21) to the top; Replace
the filler cap (20).
−
Always use clean recommended oil, see step 1.2 on
page 2.
−
Do not use old or recycled oil.
−
Do not use hydraulic brake fluid.
IMPORTANT: Ensure that disposal of used oil is in
accordance with current legislation.
− Dust, sand and dirt are a danger for any hydraulic device.
− Every day, after use, the tool must be wiped with a clean
cloth, taking care to remove any residue, especially close
to pivots and moveable parts. Protect the tool from rain
and moisture. Water will damage the tool and battery.
− To prevent damage, when not in use, the tool should be
stored and transported in the plastic case.
• The case is suitable for storing the tool and its
accessories.
•
Case Dimensions: 542x412x197 mm (21.3x16.2x7.7 in.)
and weight 3,2 kg (7 lbs).
ADDING OIL
CLEANING
STORAGE
The tool is robust, completely sealed and requires very little daily maintenance. Compliance with the following points should help
to maintain the optimum performance of the tool:
4.0
MAINTENANCE
4.1
4.3
4.2
5.0
PARTS LIST
for Type 2
The warranty is void if parts used are not original Thomas & Betts parts.
When ordering spare parts always specify the following:
−
Code Number of Item
−
Name of Item
−
Type of Tool
−
Tool Serial Number
See Figure 4 for complete tool assembly.