5
6
7
1
2
4
4
Ni-MH
3
3
8
11
600
24
27
2
13
See 3.1
(Fig. 4)
1.0
GENERAL CHARACTERISTICS
BATTERY OPERATED
HYDRAULIC CRIMPING TOOL
This “BPI42CR” hydraulic tool is powered by 9.6 V DC
Ni-MH battery. The tool is well balanced for optimum
control, quiet operation, very little vibration and
lightweight construction enabling the operator to hold the
tool in one hand while positioning the connector with the
other hand. It is equipped with an automatic system that
opens the dies once the crimping operation is completed.
The residual battery capacity level is automatically
displayed after every cycle.
BPI42CR includes the following:
•
Battery
• Wrist Strap
• Spare Battery
• Battery Charger • Carrying Case
BPI42300CR includes the following:
• Battery
• Wrist Strap • Spare Battery
• Battery Charger • Carrying Case
• Die Set
Suitable for installing electric compression connectors
for conductors from 8 AWG up to 300 Cu, 4/0 AL
Crimping Force Nominal
4 Tons
Rated Operating Pressure
5600 psi
Dimensions:
Length
14 6”
Width
4 2”
Height
2 6”
Weight
(with battery) 5 3 lbs
Motor
9 6V DC
Battery - direct current
9 6 V - 2 0 Ah Ni-MH
Oil Recommended
AGIP ARNICA 22 or
SHELL TELLUS TX22 or equivalent
Safety
the tool is provided with a
maximum pressure relief safety valve
(Directive 2006/42/EC, annexe 1, point 1.7.4.2 letter u)
The weighted continuous acoustic pressure level
equivalent
A at the work place L
PA
is equal to............66.8 dB (A)
The maximum value of the weighted acoustic
displacement pressure
C at the work place L
pCPeak
is....................<130 dB (C)
The acoustic power level emitted by the machine
L
WA
is equal to...............................................75 dB (A)
(Directive 2006/42/EC, annexe 1, point 2.2.1.1)
Tests performed in compliance with UNI ENV 25349
and UNI EN 28663 part 1st Standards, and under
operating conditions more severe than normal,
certify that the weighted root mean square in
frequency of the acceleration the upper limbs are
exposed to for each biodynamic reference axis does
not exceed 2.5 m/sec
2
1.5
OVERALL VIEW
1.1
APPLICATION RANGE
1.2
3
Operating Button
8
Pressure Release Button
13
Wrist Strap
24
Upper Die Support
11
Battery Condition Display
27
Lower Die Support
2
Battery
600
Head Complete
RISK DUE TO VIBRATION
ACOUSTIC NOISE
1.3
1.4
Fig. 1
TA04492 B Page 2 of 8
WARNING
1. BEFORE USING THE TOOL, CAREFULLY READ
INSTRUCTIONS IN THIS MANUAL.
2. WHEN OPERATING THE TOOL NEVER PLACE HANDS OR
OTHER BODY PARTS BETWEEN THE CRIMPING DIES.
3. DO NOT USE IN WATER OR IN THE RAIN.
4. ALWAYS ENSURE CORRECT LATCHING AND SECURITY
OF THE TOOL HEAD.
5. DO NOT SHORT CIRCUIT THE BATTERY TERMINALS.
6. ALWAYS RECYCLE THE BATTERIES.
7. DO NOT DISCARD BATTERIES INTO DOMESTIC REFUSE
OR WASTE DISPOSAL.
