
ASSEMBLY
ASSEMBLY
1 2
1 3
T H M F I B U L A
T H M F I B U L A
Pull both parts of the adjuster together.
Then unscrew the nut
(5) on the adjuster through
approximately 2 rotations.
(fig. 11)
If necessary, remove your old inner brake cables.
ASSEMBLING THE BRAKE CABLES
9
Position 1
19-25 mm
10
25-28 mm
Position 2
RIM WIDTH ASSEMBLY
The Fibula is made for two ranges of rim width. (fig. 9, 10)
To change the range of use proceed as follows:
Loosen the clamping screw
(1) using a 2 mm Allen key.
Do not turn the screw completely out of the eccentric.
Turn the eccentric wheel in your desired position
against the stop.
Tighten the clamping screw
(1) with a torque of ca. 1 Nm
(9 lbf·in).
(fig. 8)
8
1
5
11
Insert the adjuster
(6) into its seating.
Press the brake blocks together firmly.
When the brake block is in this position make sure
that the outer sheath of your brake cable is neither too
short nor too long, and that it can be installed correctly.
Adjust the outer sheath of your brake cable if necessary.
(fig. 12)
Install the new inner brake cable
(7).
(fig. 13)
6
12
13
7