Thinkware BAB-95, Все в одном: краткое руководство по началу работы

Страница: 9 / 20

7
English
Operation modes depending on the power switch settings
Power switch setting Operation mode
LOW HIGH
Normal-speed charge ON (6.5 A)
LOW HIGH
Power OFF
LOW HIGH
High-speed charge ON (8.5 A)
Caution - When setting the power switch
Set the power switch to HIGH (high-speed charge) when you use the charging cable for the fuse box. It
will take more time to fully charge if the power switch is set to LOW (normal-speed charge).
Product features
•
With its 8.5 A high-speed charging, the external battery is capable of operating a dash cam
for up to 27 hours on approximately 50-minute charge (based on a power consumption rate
of 3.5 Wh).
•
The charge pump and constant voltage/current circuits integrated into the product are
capable of fully charging and maintaining the external battery in optimal conditions
(maintains over 80% capacity after 1,500 cycles).
•
The MCU-controlled battery management system in the external battery safely and precisely
controls the charge current and voltage, and the voltage balance between the battery cells.
•
The thermal protection feature stops charging when the battery temperature reaches or
exceeds 176°F (80°C). If the input terminal is connected wrongly, such as by connecting the
continuous power (B+) and GND the other way, the device automatically stops battery output
to protect itself.
•
The device automatically stops battery output when short circuits are detected between the
power terminals (B+, ACC) and the ground (GND). Charge the external battery to deactivate
the protective feature if the protection mode persists.
•
The device automatically stops battery output when the battery voltage drops below or
reaches 11.5 V - 10.8 V.
•
Supports parallel installation of two external batteries to expand battery capacity.
(Refer to “Wiring diagram” for details.)