ThinkPad Edge E445, Руководство по техническому обслуживанию аппаратной части

Страница: 43 / 113

Power-on password
A power-on password protects the system from being turned on by an unauthorized person. The password
must be entered before the operating system can be started. For instructions on how to remove the
power-on password, see “How to remove the power-on password” on page 37.
Hard disk password
There are two hard disk passwords:
• User hard disk password - for the user
• Master hard disk password - for the system administrator, who can use it to get access to the hard disk
even if the user has changed the user hard disk password.
Note: There are two modes for the hard disk password: User only and User . The User
mode requires two hard disk passwords; the system administrator enters both in the same operation. The
system administrator then provides the user hard disk password to the system user.
Attention: If the user hard disk password has been forgotten, check whether a master hard disk password
has been set. If a master hard disk password has been set, it can be used to access the hard disk drive. If
no master hard disk password is available, neither Lenovo nor Lenovo authorized service technicians provide
any services to reset either the user hard disk password or the master hard disk password, or to recover data
from the hard disk drive. The hard disk drive can be replaced for a scheduled fee.
For instructions on how to remove the hard disk password, see “How to remove the hard disk password”
on page 38.
Supervisor password
A supervisor password protects the system information stored in the ThinkPad Setup program. The user
must enter the supervisor password in order to get access to the ThinkPad Setup program and change the
system configuration.
Attention: If the supervisor password has been forgotten and cannot be made available to the service
technician, there is no service procedure to reset the password. The system board must be replaced for
a scheduled fee.
How to remove the power-on password
To remove the power-on password, do one of the following:
If no supervisor password has been set, do the following to remove the power-on password:
1. Turn off the computer.
2. Remove the battery pack. For instructions on how to remove the battery pack, see “1010 Battery
pack” on page 62.
3. Remove the backup battery. For instructions on how to remove the backup battery, see “1080 Backup
battery” on page 70.
4. Turn on the computer and wait until the POST ends. After the POST ends, the password prompt will not
be displayed. The power-on password has been removed.
5. Reinstall the backup battery and the battery pack.
If a supervisor password has been set and is known to the service technician, do the following to remove
the power-on password:
1. Turn on the computer.
2. When the ThinkPad logo is displayed, immediately press F1.
Chapter 4
.
Related service information
37