Thinklogical Velocity RGB-9, Руководство по эксплуатации продукта

Страница: 16 / 33

16
JUNE 2009 REVISION B
Some menu options may not be available on some models
Display Modifiable Description
*System
LS Connected NO An indication of the fiber status from the TX to RX.
TX Ctrl Name TX Only Name entered on TX unit is displayed on RX unit.
Load Defaults YES Loads factory default video configurations.
Store Values YES Store video configurations.
TX Control NO Revision of the TX control firmware.
RX Control NO Revision of the RX control firmware.
FPGA Version NO Revision of the FPGA code
Serial Number YES Serial Number of unit.
Aud Reset En YES Resets the audio sync circuitry
SFP Loss of Signal NO An indication of fiber status on the extender Receive channel. Value =
0 if signal is received, 1 if signal is missing.
Debug Values YES Factory Use Only.
Display Modifiable Description
*DDC – To be implemented at a later date
DDC PROM Emula. Mode YES Options are Dynamic, Static and Passthru.
In Dynamic mode, the DDC of the monitor connected to the RX is read
and stored on the TX. The CPU is informed of a change in DDC and
the monitor is read. This is useful when the CPU can be turned on
without a connection to the RX.
Static mode is used to maintain the
current DDC regardless of monitor changes at the RX. Pass-thru acts
as a wire between the TX and RX and no emulation takes place.
Load Default DDC YES Loads the default EDID table into the TX and changes the mode to
Static.
Acquire DDC YES Gets the EDID table from the monitor attached to the RX and stores it
in the TX.
Force DDC mode YES Sets the EDID Video Input Signal Type to either analog or digital.
* Video
VGA Connected NO An indication of whether VGA video is input to the TX
Resolution input NO Active pixels x active lines vertical rate
Hor. Freq NO Horizontal frequency
Auto Phase YES Automatically adjust the Sampling Phase to the best setting
PLL Total YES The total pixel count in one line.