Think Appliances Venini_VCH92G, Руководство пользователя

Страница: 25 / 29

2) Fix the angle bars to the hanging plate, using
the 8 x M4 nuts and bolts with metal washers.
3) Extend the angle bars to the required height
and then fix them in position using the 16 x M4
nuts and bolts with metal washers.
o
IMPORTANT: The angle bars must have
an overlap of AT LEAST 100 mm.
4) If your cooker hood is going to be used in
extraction mode, then you should connect the
ducting hose to the ceiling adaptor at this point.
o
Fix the upper chimney section to the
hanging plate, using the 4 x self tapping
screws.
o
Slide the lower chimney section onto the
angle bars and raise it until it sits just
below the upper chimney section.
o
Use the hanging hook to temporarily keep the lower chimney
section in this position, to make sure that it does not drop down
whilst fixing the main body of the hood to the angle bars.
5) If you are going to be using the hood in
extraction mode, you should fit the spigot for the
duct hose onto the main body of the cooker
hood, using the 4 x M4 bolts,
24