o
The cable connections must be in accordance with the diagram
located on the bottom of the cooktop (see previous page). The links
must also be positioned as indicated.
o
You should use a good quality screwdriver to carefully, fully tighten
ALL of the terminal screws.
o
If when the cooktop is first switched on, only two of the
zones work, you should recheck that the terminal screws are
all fully tightened and the links are in position. This should
be done before contacting the Customer Care Department.
o
IMPORTANT: The appliance must NOT be connected to the mains
supply by means of a 10A or 15A plug and socket.
o
The cable can be looped if necessary, but make sure that is not
kinked or trapped when the cooktop is in position. Care must be
taken to avoid the cable being in contact with hot parts of the
appliance.
Replacing the mains supply cable
If the mains supply cable is damaged, then it must be replaced by an
appropriate replacement which can be obtained via the manufacturer
or its service agents, in order to avoid hazard.
The mains supply cable should be replaced in accordance with the
following instructions:
o
Switch the appliance off at the socket.
o
Open the terminal block on the underside of the cooktop.
o
Unscrew the terminal screws fixing the cable.
o
Replace the cable with one of the same length and in accordance
with the specification given on pages
15-16.
o
The “green-yellow” earth wire must be connected to the terminal
marked
. It must be about 10 mm longer than the live and
neutral wires.
o
The “blue” neutral wire must be connected to the terminal
marked with letter (N) - the live wire must be connected to the
terminal marked with letter (L).
16
