THAN0184_Rev.1.00_E
THine Electronics, Inc.
Security D
2/9
Copyright(C) 2015 THine Electronics, Inc.
4. Power Supply Set Up
This chapter shows power supply condition.
Caution: Please check if there is no power-GND short on below red trace before supplying any power.
3.3V Power Supply to Each Board
Each evaluation board require 3.3V power supply. Please use “CON1” connector typically.
3.3V Power Supply
Ground
(a)THEVAM83D
(b) THEVAF(R)84B, 84C
Figure 3 Power Supply for Evaluation Board
Power Supply from / to Connector
3.3V power supply can be connected to Header1 and CON2 by using W1 and W2solder jumper.
THEVAM83D
W1: Connect the 3.3V power supply with pin#29 and 30 of CON2.
W2: Connect the 3.3V power supply with pin#1, 2 and 3 of Header1.
Figure 4 THEVAM83D Power Supply from / to Each Connector