2/11
THAN0185_Rev.1.20_E
Copyright(C)
2016 THine Electronics, Inc.
THine Electronics, Inc.
Security E
2. Power Supply Setup
This chapter shows power supply condition.
Caution: Please check if there is no power-GND short on below red trace before supplying any power.
3.3V Power Supply to Each Board
Each evaluation board requires 3.3V power supply. Please use “CON1” connector typically.
(a)THEVA1023B (b)THEVA1024
Figure 2 Power Supply for Evaluation Board
Power Supply from / to Connector
3.3V power supply can be connected to Header1 and CON2 by using W1, W2 and W3solder jumper.
THEVA1023B
W1: Connect the 3.3V power supply with pin#1, 2 and 3 of Header1.
W2: Connect the 3.3V power supply with pin#13 and 14 of CON2.
W3: Connect the 3.3V power supply with pin#1, 2 and 3 of Header2.
Figure 3 THEVA1023B Power Supply from / to Each Connector
3.3V Power Supply
Ground
3.3V Power Supply
Ground
W1
W2
W3
Downloaded from
Downloaded from
