MOUNTING INSTRUCTIONS
OCTA STAR SELF-LOCKING HOOKS
GRADE 80
THIELE GmbH & Co. KG
# change indicator
www.thiele.de | [email protected]
B10751-A
replaces -
© All rights reserved.
US 12.2021
1 | 5
Self-locking
Eye Hook
Self-locking
Clevis Hook
The following mounting instructions must always be
followed to avoid the risk of personal injury or property
damage.
Do not use a self-locking hook before reading these
mounting instructions.
1.
ABOUT THIS INSTRUCTION
These mounting instructions describes in particular how
OCTA STAR self-locking hooks are to be safely used for lifting
purposes.
To comply with these instructions is essential to help avoiding
hazards and increases the reliability and service life of the self-
locking hook.
DANGER!
Indicates
a
hazardous
situation which, if not avoided, will
result in death or serious injury.
WARNING
! Indicates a hazardous
situation which, if not avoided, could
result in death or serious injury.
CAUTION!
Indicates a hazardous
situation which, if not avoided, could
result in minor or moderate injury.
NOTICE!
Is used to address practices
not related to physical injury.
Safety Instructions
signs indicate
specific safety-related instructions or
procedures.
DEFINITIONS
Clevis
A U-shaped fitting with pin.
Working Load Limit (WLL)
The maximum load, which a self-locking hook is designed to
support.
Read ASME B30.10 „Hooks“.
Read ASME B30.26 “Rigging Hardware”,
Chapters 26-0, 26-1, 26-4.
2.
BASIC SAFETY REQUIREMENTS
To prevent the risk of injury never walk or stay under lifted
loads!
The working load limit (WLL) must not be exceeded!
Self-locking hooks as well as lifting and attachment means
to be used must be free from defects!
Working under the influence of drugs, medications
impairing the sense and/or alcohol is strictly forbidden!
•
Operators, fitters and maintenance personnel must in
particular observe the operating instructions of the chain
slings into which the self-locking hooks are to be installed, as
well as standards ASTM A 906/A 906 M (Standard
Specification for Grade 80 and Grade 100 Alloy Steel Chain
Slings for Overhead Lifting), ASTM A 952/A 952 M (Standard
Specification for Forged Grade 80 and Grade 100 Steel Lifting
Components and Welded Attachment Links), ISO 3056 (Non-
calibrated round steel link lifting chain and chain slings; Use
and maintenance), ISO 7593 (Chain slings assembled by
methods other than welding; Grade T(8)) and ISO 4778
(Round steel short link chains for lifting purposes – Chains
slings of welded construction – Grade 8), ISO 1837 Lifting
hooks - Nomenclature.
•
The specific safety and operating regulations and standards
issued locally in the country where the items are used must
be observed.
•
The directions given in these mounting instructions and
specified documentations relating to safety, assembly,
operation, inspection, and maintenance must be made
available to persons operating and using the self-locking
hooks.
•
Make sure these mounting instructions are available in a
place near the product during the time the equipment is
used. Please contact the manufacturer if replacements are
needed. Also see chapter 12.
•
During operation work, wear your personal protective
equipment!
•
Improper assembly and use may cause personal injury
and/or damage to property.
