INSTALLATION
Fixing
The appliance can be front or side fixed, holes are provided for either installation method.
Fixing screw positions are located as follows.
Appliance
Front Fixed Appliance
Side Fixed Appliance
S~OH70000Z
&
S~OH71000Z
2
front
fix holes each side of
Oven opening
2 fix holes each hotplate side trim
2
side
fix holes each side of
Oven opening
2 fix holes each hotplate side trim
IMPORTANT
•
This appliance must be installed into an aperture, sealed off at either side in order to
prevent draughts from adjoining cupboards/vents. Ensure that air vents and gas
escape holes are kept clear, holes for cables and pipes must be sized to minimize air
leakage between compartments.
•
Under no circumstances should the ventilation hole exceed the maximum size
specified. Low level vents in adjacent compartments are permitted.
•
Any cupboards beneath the appliance
MUST
be sealed to prevent a gas escape
entering the living area.
Connection
A ¼ BSP female connection is provided for gas inlet, on the rear of the appliance. It is
recommended that the appliance be connected by copper tubing, a rubber or hose connection
must not be used. After connection the appliance must be tested for soundness.
This appliance is suitable for use on –
Propane Gas Only 2.75 Kpa
.
It is important that the regulator should be set to the correct pressure for the type of gas being
used. Excessive pressure must not be permitted.
If the flame on either the top burners or the grill show a tendency to lift, it is probable that the
line pressure is too great. Should there be excessive yellow tips (resulting in sooting) then it is
probable that the line pressure is too low and, in either case, the burners should not be used
until the line pressure has been checked.
This appliance is fitted with the following injectors:-
HOB
0.81mm 9.0 MJ/h
0.67mm 6.1 MJ/h
0.62mm 5.3 MJ/h
0.53mm 3.8 MJ/h
GRILL
0.62mm 5.3 MJ/h
OVEN
0.65mm 5.8 MJ/h
The burners on this appliance have fixed aeration and no adjustment is necessary.
12
