Theta Digital Dreadnaught III, Руководство пользователя

Страница: 15 / 24

8
13. SINGLE-ENDED input jack – Channel A on two channel module.
14. POSITIVE BINDING POST – Channel B. (Two channel module). Connects to the + (plus) speaker connector.
The binding posts on the two channel module can accept spade lugs, banana plugs or bare wire.
15. NEGATIVE BINDING POST – Channel B. (Two channel module). Connects to the – (minus) speaker connector.
16. STEREO/SURROUND bus selector switch. Assigns the affected module (both channels) to either the STEREO or
SURROUND buss.
17. BALANCED input jack – Channel B of two channel module.
18. SINGLE-ENDED input jack – Channel B on two channel module.
19. SURROUND REMOTE TRIGGER jack. When the rear panel SURROUND TRIGGER jack receives a change in the
12V (0V to 12V or 12V to 0V) the amp’s surround mode will change from its current status, either on or off.
20. DB9
RS-232 connector. Used for connecting a system control device to the Dreadnaught III to control and
monitor its functions.
21. RJ45 RS-232 connector. See DB9 RS-232 connector, above.
22. STANDBY REMOTE TRIGGER jack. When the rear panel STANDBY TRIGGER jack receives a change in the 12V
(0V to 12V or 12V to 0V) the amp’s standby mode will change from its current status, either on or off.
23. MAIN POWER Switch. Master power switch. Disconnects AC to all circuits. It is recommended that this be left
ON at all times during regular use with the exception of whenever cables are connected/disconnected or when
the unit is not going to be used for an extended period of time.
24. Rear panel FUSE . If necessary to replace, use same type and rating only.
25. AC POWER INPUT .