ThermoTex SorTexx, Руководство по эксплуатации

Страница: 22 / 26

Data protocol
GBSOTXBA_V(1).DOCX Page - 22
5.5.9 Reset
Command byte “R”
Description All modules are reset. The LEDs are switched off and the button memories are cleared.
The buffer memory is also cleared.
Parameter -
Answer Result byte: see chapter 5.3
Broadcast possible The command applies to all modules; shelf number and compartment number are
ignored.
Note: In operation mode “Counting Frame” the RESET command will not clear the counter values. Please use
the „Clear Value“ command.
5.5.10 Signal transducer ON and OFF
Command byte “S”
Description The signal transducer connected to the control unit is switched on or off.
Parameter “0”: OFF
“1”: ON
Answer Result byte: see chapter 5.3
Broadcast possible Not applicable. Shelf number and compartment number are ignored
5.5.11 Sensor delay time
Command byte „T“
Description Set the sensor delay time. This value determines how long a button (or sensor) needs to
be activated before the button memory is set to “1”.
Parameter „0“: 0 ms
„1“: 1 ms
„2“: 2 ms (default for Counting Frame)
„3“: 5 ms
„4”: 10 ms
„5“: 20 ms (default for IN-SorTexx and OUT-SorTexx)
„6“: 50 ms
„7“: 100 ms
„8“: 200 ms
„9“: 500 ms
Answer Result byte: see chapter 5.3
Broadcast possible yes
5.5.12 Counting frame: Poll counter value
Command byte „U“
Description Returns the current counter value.
If “send value automatically“ is activated (menu 2), the control unit will automatically send
any value that has changed.
Example: „<008502U00>“ means that counter 2 has a value of 85
Parameter -
Answer Result byte: see chapter 5.3
Bytes 1…4 contain the counter value („0000“…“9999“)
Broadcast possible Yes. The counter values of all connected counting frames will be sent consecutively.