THERMOROSSI ECOTHERM 5000 Скачать руководство пользователя страница 4

Страница: 4 / 28

pg. 4

TECHNICAL CHARA

TECHNICAL CHARACTERISTICS *

CTERISTICS *

1 . 4

TRANSPOR

TRANSPORT

ATION

TION

TION AND ST

AND ST

AND STORA

ORA

ORAGE

G E

TRANSPORTATION AND HANDLING
The heater body must always be in a vertical position when handled and exclusively by means of trolleys. Take special care to protect the
electric panel, the glass, the ceramics and all the fragile parts from mechanical impact which could damage them and their correct
functioning.
STORAGE
The heater must be stored in a humid-free environment and sheltered from the weather; do not place the heater directly on the floor. The
Company denies all responsibility for damage caused to wood floors or floors made from any other material. It is inadvisable to store the

heater for long periods of time.

* All the data are based on the appliance fuelled with Austrian standard ÖNORM M 7135 type-
approved pellets.

1 . 3

S T

S TAND

AND

ANDARDS

ARDS

ARDS AND RECOMMEND

AND RECOMMEND

AND RECOMMENDA

ATIONS

TIONS

NORMATIVE REFERENCES :national and international standards used as reference guides in the following manual for the design, industrialization

and production of the products:

- European directive 73/23/EEC

- Standard CEI 61/50 - European directive 93/68/EEC

- Standard CEI EN 60204 - European directive 89/336/EEC

- Standard CEI 64-8 (IEC 364)

- European directive EN 14785: 2006

RECOMMENDATIONS
Before using the appliance, carefully read every section of this instruction manual as knowledge of the information and the regulations contained
in it are essential for a correct use of the appliance.
The entire operation concerning the connection of the electric panel must be carried out by expert personnel; no responsibility will be accepted
for damages, even to third parties, if the instructions for installation, use and maintenance of the appliance are not followed scrupulously.
Modifications made to the appliance by the user or on his behalf, must be considered to be under his complete responsibility. The user is
responsible for all the operations required for the installation and maintenance of the appliance before and during its use.
GENERAL WARNINGS
Caution: the appliance must be connected to a system provided with a PE conductor (in compliance with the specifications of 73/23/EEC, 93/
98/EEC, concerning low voltage equipment).
Before installing the appliance check the efficiency of the earth circuit of the power supply system. Caution: the power supply line must have
a section which is suitable for the power of the equipment. The cable section must in any case be no less than 1.5 mm². The appliance must be
powered with a voltage of 220/240 V and 50 Hz. Voltage variations which exceed 10% of the nominal value can cause poor functioning or
damage the electrical device. Position the appliance so that the electric power plug is easily accessible. Voltage variations less than 10% of the
nominal value can cause lighting and use problems. Apply a current regulator. Ensure that a suitable differential switch is installed upstream from
the equipment.