14
06/2015, JK
Toggle Prompt
Command:
<cr>
Response (toggle on):
<cr><lf>>
Response (toggle off):
<cr><lf>
Remarks: No temperatures are sent while prompt mode is on. Temperature sending will resume once the
prompt is toggled off. If other functions are used while the prompt is on, the responses are preceded
by a prompt <cr><lf>
>.
Set Date
Command:
D YY-MM-DD<cr>
Response (success):
New Date is: YYYY-MM-DD<cr><lf>
Response (failure):
Error – use format "> D(ate) (YY)YY-MM-DD"<cr><lf>
Remarks: A lower case "d" or the word "Date" can be used.
Set Time
Command:
T HH:MM:SS<cr>
Response (success):
New Time is: HH:MM:SS<cr><lf>
Response (failure):
Error – use format "> T(ime) HH:MM:SS"<cr><lf>
Remarks: A lower case "t" or the word "Time" can be used.
Set Rate
Command:
R [0,1,30,60,3600,poll]<cr> (e.g. R 1<cr>, R 30<cr>, r poll<cr>
Response (success):
Send Rate: X sec.<cr><lf>
Send Rate: Poll (enter ? For a temp.)<cr><lf>
Response (failure):
Rate Format">R X" (X =1,10,30,60,3600,Poll)<cr><lf>.
Remarks: The brackets contain the options, separated by commas. (e.g. R 10<cr>, R poll<cr>). A lower case r
or the word Rate (or rate) can be used. Entering 0 is the same as entering poll.
Poll Temperature
Command:
?<cr>
Response (success):
Response (failure): The TL2-A sends the temperature now, regardless of the temperature send rate. (When in
polling mode, the TL2-A only sends temperatures when it is polled.) Polling for a temperature resets
the timer for the 10-3600 second rate (the next temperature will be sent <rate> seconds from the
polled temperature.
Remarks: Polling can be used when not in polling mode to synchronize the send rate. It can be used in polling
mode to get the temperature exactly when it is needed.
Version
Command:
V<cr>
Response (success): A lower case v can be used. Sends the TL2-A firmware version for the main and accessory
boards.
Response (failure): none
Remarks: The version information is useful when verifying that the correct firmware has been loaded on the
TL2-A.
