5
20.
Install junction box lid and twist hand tight.
Insert screwdriver into ratchet slots located on
side of junction box base.
22.
Lid latch mechanism fully engaged. To remove
lid, repeat steps 20 and 21 but in the opposite
direction.
21.
Use screwdriver to ratchet on junction box lid.
Lid will rotate 30 degrees.
A2.
Insert two cables into expediter.
A1.
Cut end of cable at angle to aid in piercing
grommet. Leave additional cable for expansion
loop.
In-line Splice Layout Tips
INSTALLATION PROCEDURES
Wiring Details Two Conductors
B3.
Wiring Details: End Termination. Install jumper
to terminal block.
B2.
Wiring Details: In-Line Splice
B1.
Wiring Details: Single Phase Circuit
Heat Tracing
Power Supply
N
L1
PE
Heat Tracing
Heat Tracing
