page 4 / 6
Issue date: 30.09.2022
Thermokon Sensortechnik GmbH, Platanenweg 1, 35756 Mittenaar, Germany · tel: +49 2778/6960-0 · fax: -400 · www.thermokon.com · [email protected]
thanos_EVO_LON_Datasheet_en.docx © 2022
»
CONNECTION PLAN
Room operating unit – active LON
The power supply and the bus line are connected via socket
terminals on the rear of the device.
When the service pin is activated, the service pin telegram is transmitted
with the LON device identification - the Neuron chip ID.
On the side of the lower part of the housing there is a socket
connector for connecting up to 2 digital inputs and an NTC10k. The
connection is made via a pre-assembled female connector
(included in delivery).
»
MOUNTING ADVICES
Please make sure that the device is de-energized if you want to install it!
The installation can be performed on the flat wall surface or on a flush-mounted box. A representative place should be selected. Sunshine and
draft, e.g. in the installation tube should be avoided, so that the measurement result is not falsified. Seal the end of the installation tube.
•
For wiring, the upper part of the device must be removed from the base plate. Base plate and upper part are detachably connected to
each other by means of locking lugs.
•
The mounting of the base plate on the flat wall surface is done with rawplugs and screws.
•
Finally, the device is attached to the base plate and fixed with the screw.
Snap the upper part of the housing into the locking lug on the
upper side
Fix the upper part of the housing on the underside with the
screw
Service LED
Service PIN
weiß
gelb
grün
rot
grau
blau
