Program description
FB-KE: 07
SRC KNX
Rev 1
SRC_KNX_620_BMA_E_2009_10_08_001.doc
Seite 3 von 14
Erstellt am 12.01.2010
Linking with EnOcean devices
Before linking to EnOcean devices, the functions of the individual channels must be programmed with the ETS. Up to
four links can be learned per channel for touch sensors, window handles and window contacts. For temperature
sensors, light sensors, presence detectors and binary inputs, only one EnOcean device can be learned per channel.
Learn mode
During the learning procedure of EnOcean sensors, the gateway is controlled using the two keys below the display:
Short keystroke, left key:
Start learn mode ("Active")
Long keystroke
,
left key:
Clear channel ("Erase")
Short keystroke
,
right key:
Send test telegram via KNX ("Test")
Long keystroke
,
right key:
Leave learn mode ("Exit")
"Long keystroke" means pressing the key for at least 2 seconds.
When the device is in normal mode, brief pressure on the left key switches it into learn mode. Briefly pressing the left
key again switches to the next channel. The display alternates between the current channel number and the number
of connected EnOcean devices. A dot in the center of the display indicates that the number of EnOcean devices is
being displayed.
To the left of the dot is the function that is set for that particular channel in the parameter settings:
A: Switching
B: Dimming with stop telegram (b)
C: Blind
D: Temperature sensor (d)
E: Window contact
F: Other sensor
-: Channel not in use
To the right of the dot is the number of connected devices. If a further connection to this channel is not possible, the
display shows an “F”.
In learn mode, a sending EnOcean device can be connected to a cable if the device type matches the function
defined in the parameter settings.
A connection is created by pressing the learn key (temperature sensor, window contact, light sensor, presence
detector, binary input) or the key (switch module) on the EnOcean device. The window handle is learned in by
moving it to a new position.
If the parameter settings specify that learning takes place by activating the key/window handle three times, the time
between the individual activations must not exceed 0.5 seconds.
If “Switching“, “Dimming“ or “Blind“ is selected in the channel parameter settings, the channel can be linked with up to
four different rocker switches or keys (with one-key control).
For the rocker functions, two opposite keys on a switch module are grouped to one rocker, so that up to four different
rockers can be linked per channel.
By briefly activating the right key, the last values of the communication objects linked to this channel are sent on the
bus if the communication objects are assigned group addresses.
Learn mode is terminated with a long keystroke on the right key or automatically if not operated for over 5 minutes.
Deleting assignments
Links to EnOcean devices are deleted by:
Long keystroke on the left key in learn mode (all links of the current channel)
Programming of the application program via the ETS (all links of all channels) if this function is selected via the
following parameter: "Delete learned EnOcean sensors after programming the ETS application“.
