ThermoFlow Elex 18, Монтаж и инструкция пользователя

Страница: 18 / 28

DE GB
18
See image 1
Remove the top of the housing with a cross-head screwdriver. Unscrew the fixing screw of the clad-
ding (see image 1) and then remove the cladding (see image 2).
See image 2
Install the supplied plumbing components as illustrated. The cold water isolation valve (stop valve)
should not be used to choke the flow through the device.
Installation, See image 3
1. Use two pieces of self-adhesive tape to fix the template on the wall where the device is
to be installed.
2. Drill two 8mm holes through the template, as indicated.
3. Bear in mind where the water pipes will be installed later.
4. Install the device with the supplied screws and plugs.
5. Install the hot and cold water pipes and supply cable as shown on the template.
See image 4
The cold water supply should be connected to the inlet on the right of the device (blue = cold
water). The hot water pipe is installed on the left. Make sure the connections are watertight!
To prepare the connection to the water supply Teflon tape must be used for sealing the pipes.
See image 5
The electrical connection should be made by a qualified electrical installer, in accordance with
the relevant regulations (IEEE, etc.).
The device has been prepared for connection to the electrical supply.
See image 6
Cut the cable to the required length and connect it to the terminal strip. Use the supplied cable boot
to obtain a good seal.
See image 7
This appliance should be earthed.
See image 8
The connections are protected to IP24 (splash proof).
Final installation
• Open the cold water stop valve.
• Install the top of the housing.
• Insert the fixing screw at the bottom.
Commissioning
• Fill the device and vent it by opening a hot water tap connected to it.
• Only switch on the electrical supply once the device is clear of any air.
• Check the operation of the device.