ThermoFisher Scientific Vanquish VC-D50, Руководство по эксплуатации

Страница: 71 / 188

5 • Installation
Fluorescence Detectors (VC-D50, VC-D51, VF-D50, VF-D51)
Operating Manual Page 71
5.6.5 Flow Connections to the Flow Cell
Connect the inlet capillary and waste line to the flow cell when the flow
cell is installed to the device.
NOTICE
Backpressures that exceed the specified maximum pressure limit of the
flow cell can destroy the flow cell. Observe the following:
• Use only the waste line connection that is provided for your
detector.
• Connect the waste line to the flow cell only as described in the
manual.
• Do not discharge waste from the flow cell through the open leakage
drain system of the Vanquish system.
• Never expose the flow cell to excessive backpressure.
• Avoid clogging of the flow cell or waste line.
• When connecting a component in the flow path after the flow cell,
observe the specified backpressure for the flow cell.
In addition, observe the guidelines for proper connection of the flow cell
in
General Information and Guidelines ( } page 64) .
Parts required
• Inlet capillary, depending on your system arrangement:
¨
The detector is the only detector in the Vanquish system
Use the inlet capillary from the system ship kit.
¨ The detector is the second detector in the Vanquish system
Use the larger ID capillary shipped with the detector.
• Detector waste line
For instructions on connecting the waste line, follow the steps in
Connecting the Detector Waste Line ( } page 75) .
Tools required
For the detector waste line: Tubing cutter (optional)
Preparations
1. Flush the system modules and capillaries upstream of the device to
waste before you connect the flow cell to the system flow path.
Refer to the
Vanquish System Operating Manual .