ThermoFisher Scientific HERASAFE 2030i Series, Руководство по эксплуатации

Страница: 84 / 173

| Operation
74
|
50155215 Herasafe 2030i / Maxisafe 2030i
Chapter 6
The “Settings” screen opens up when you tap the “Settings” icon in the Main
Navigation Bar. It offers nine menu items that can be tapped to open further screens with
advanced adjustment options:

“Disinfection Cycle Settings”: See “Setting UV Disinfection Cycle Time” on page 74.

“Display Settings”: See “Display Settings” on page 77.

“Programs”: See “Programs” on page 86.

“Alarms and Alerts”: See “Alarms and Alerts” on page 91.

“Data Plate”: See “Data Plate” on page 97.

“Connectivity”: See “Connectivity” on page 98

“Firmware”: See “Firmware Update” on page 112

“Access Control” (password protected): See “Access Control” on page 112.

“Field Certification” (password protected): See “Field Certification” on page 113.

“Factory Settings” (password protected): See “Factory Settings” on page 113.
Setting UV Disinfection Cycle Time
Tapping the “Disinfection Cycle Settings” button takes you to the “Disinfection Cycle
Settings” screen, shown in Figure 69 below. From this screen, you can change the default
running time of the UV disinfection cycle. This value is used by default when you start the
Disinfection cycle by tapping the “UV light” button in the Control Panel Area of the display window.
Figure 69 “Disinfection Cycle Settings” Screen
The “Disinfection Cycle Settings” screen displays the following fields:

“UV runtime setting”: Sets the duration of the UV Disinfection cycle from 0 to 24
hours, with additional intervals of 00, 15, 30, and 45 minutes.
NOTE Some of these items are also available as shortcuts on the Main Navigation Bar.
Thermo Fisher BSC
11:42 AM | 08/10/2018
Disinfection Cycle Settings
UV runtime setting
Auto-adjustment of UV disinfection cycle time
based on UV light bulbs operating hours.
Leave fans switched on after UV cycle has been
completed.
00 hr min 1
Save