25
Blotting E-PAGE
™
Gels
Blotting E-PAGE
™
Gels with the iBlot
®
Device
Introduction
Instructions are provided in this section to assemble the iBlot
®
Gel Transfer
Device with the De-Bubbling Roller for blotting
E-PAGE
™
Gels. The
recommended program for blotting E-PAGE
™
Gels is Program P3 at 20 volts
for 7–8 minutes.
Materials Needed
You will need the following items:
•
Pre-run E-PAGE
™
gel containing your protein samples and standards
•
iBlot
®
Gel Transfer Stack, Regular (page 70)
Removing the Gel
Remove the gel from the cassette for transfer after completion of electrophoresis
as described on page 25.
•
There is no need for any pretreatment of the gel after electrophoresis.
Wash the E-PAGE
™
gel briefly in deionized water to remove any small gel
pieces attached to the gel.
•
The transfer membrane is supplied in a ready-to-use format in the stacks
without any need for pretreatment. Do not treat the PVDF membrane with
methanol as the PVDF membrane is preactivated prior to assembly with
the transfer stack.
•
To obtain the best blotting results with the E-PAGE
™
gels, we recommend
that you use the De-bubbling Roller. For an alternative protocol using the
Blotting Roller, refer to the manual for the iBlot
®
Dry Blotting System.
Содержание E-PAGE Gels
Страница 77: ...73...