6
R
A
D
I
A
N
T
O
U
T
D
O
O
R
H
E
A T
E
R
S
INSTALLATION
INSTRUCTIONS
Ensure all minimum clearance requirements are met and the materi-
als used are compliant to your local building codes.
Before installing the FME, ensure the site to be fixed is fully pre-
pared with the hole cut the correct size and the mounting points se-
curely in place.
STEP 1: Attach the
brackets to the rear of
the heater. The dimen-
sions for the spacing of
the brackets is listed in
the table.
STEP 2: Screw the
FME into the battens.
NOTE: screws are not
included.
STEP 3: If there is no
roof access, connect the
heater to the power
source, ensure the
power is OFF.
STEP 4: Lift the heater
into the FME ensuring
the brackets are to the
side of the mounts
STEP 5: Push the
heater to the left ensur-
ing the brackets engage
in the mounts. It will
then drop in. Shake the
heater to ensure that it
is securely mounted.
MODEL
“D”
DISTANCE FROM END
TO BRACKET (mm)
THH1500A
150
THH1800A
240
THH2400A
370
THH3200A
425
HEATER
BRACKET x2
FLUSH MOUNT ENCLOSURE
TIMBER BATTEN
PLASTER CEILING
SCREWS, AT EACH END, THERE ARE 6 HOLES
WITH A DIAMETER OF 8mm EACH
ON
OFF
"D"
"D"
