Thermocet Trimline 100, Инструкции по эксплуатации и монтажу, Страница: 8 / 36

Page.8
4.0 MANUAL CONTROL
The unit may be operated by hand if there is a defect in the remote control. To do so, the ignite (piezo)cable of
the receiver must first be removed and carefully slid into the piezo connector on the gas control block.
Igniting the fire
* Open the gas shut-off cock that has been installed in the gas pipe to the unit.
* Press the “
O I ” switch, on the gas control block, in the “ I ” position.
* Turn the motor button, on the gas control block, completely to the right. The button will make a "click”
sound.
* Turn the operating button on the gas control block, into the “
MAN ” position. A metal circle in the operat-
ing button will become visible.
* Push the metal circle inwards. For example, with a pen. Gas will now flow to the pilot flame.
* While keeping the metal circle pressed down, press the (square) piezo button (along the “
O I ” switch) sev-
eral times to ignite the pilot flame. You will be able to see whether the pilot flame is burning through the
glass window.
* If the pilot flame is alight, keep the metal circle pressed down for another 10 seconds and then let go.
Important: If the pilot light extinguishes, one should wait at least 5 minutes before repeating the
aforementioned steps.
* Turn the operating button to the ON position. The burner may or may not ignite, depending on the position
of the motor button.
* By turning the motor button to the required setting to the left, the burner will ignite and the flame size can
be adjusted.
Extinguishing the fire
Turn the motor button, on the gas control block, completely to the right. The button will make a "click” sound.
The burner will turn off. The pilot flame continues to burn.
Switching the unit off
Press the " O I ” switch, on the gas control block, in the “ O ” position. The pilot flame will extinguish.
If the fireplace is not used for an extended period of time, we recommend closing the gas shut-off cock in the
supply line.
Important: If, for whatever reason, the pilot light extinguishes, you must wait 5 minutes before ignit-
ing the pilot light again.
Piëzo Knop
Piëzo Ignitter
(Manual)
Manual knob
Main valve knob
Microswitch
“ O I ” Switch
8 Wire Receiver Jack
Small metal circle for
Manual ignition
(Combination Control, Cover Manual position