USE BOTTOM KEYHOLE
SLOTS IF HEATER IS TO
BE TILTED DOWN
Figure 6
ADJUSTING AIR FLOW DIRECTION
1.
To turn the unit when it has been installed with a single lag bolt (as shown in
figure 5a), simply turn the entire heater as needed(as shown in figure 7).
The unit cannot be turned horizontally if it has been installed with 2 lag bolts.
2. To tilt the unit vertically, loosen the bracket screws (see figure 6).
3. Adjust louvers to the desired position.
NOTE:
To prevent possible overheating, please maintain adequate clearance as
shown in figure 3.
Figure 7
NOTE:
The louvers are designed so they cannot be completely closed. Do not
attempt to defeat this feature; damage to the unit can result.
MULTIPLE VERTICAL ANGLES
Keyholes
Bracket Screws
REMOVE SCREW TO
COVER