Thermo Scientific Vanquish Charger, Руководство по эксплуатации

Страница: 59 / 88

7 • Maintenance
Vanquish Charger Operating Manual Page 59
7.3.2 Cleaning the Charger
Before you start the cleaning procedure, remove the shelf and any
samples from the Charger compartment and turn off the Charger.
To keep the Charger surfaces clean, wipe the surfaces with a dry, soft,
lint-free cloth or paper. If necessary, slightly dampen the cloth with a
solution of lukewarm water and conventional dishwashing detergent, or
a special laboratory cleaning detergent. Afterward, wipe the cleaned
surfaces with clear water to ensure that all cleaning detergent residues
have been removed. Wipe the surfaces dry using a soft, lint-free cloth.
NOTICE Observe the following:
•
Some Charger components are made of plastic. Solvents may
dissolve plastics. Powerful acids or lyes may cause embrittlement of
the plastics. For cleaning the plastic components and surfaces, do
not use hydrocarbon-containing solvents, cleaning agents with an
alcohol content of more than 10 %, or powerful acids and lyes.
•
All outer surfaces of the system are resistant to weak acids, alkali,
and organic solvents. Nevertheless, wipe up all liquids spilled onto
the system immediately. If surfaces are exposed for longer periods,
these liquids can cause damage.
•
Prevent cleaning detergent from entering the flow path.
•
Never use sharp tools or brushes for cleaning any surfaces.
•
Do not use excessively wetted cloth or paper for cleaning. Prevent
any liquids from entering the functional components of the Charger.
Liquids might cause a short circuit when getting in contact with the
electronic components.