Thermo Scientific Sorvall ST Plus Series, Инструкция по эксплуатации

Страница: 68 / 172

3-36
Graphical User Interface
Figure 3–61: Settings -> Controls -> Setpoints: Advanced Screen for Ventilated Centrifuge
Proceed as follows to customize the setpoints for Standard Mode and Advanced Mode:
1. Tap the Settings icon on the navigation bar.
2. Tap the Controls button on the “Settings” screen.
The “Controls” screen appears.
3. Tap the Setpoints button.
The “Setpoints: Standard” screen or “Setpoints: Advanced” screen shown in Figure 3–61 above appears.
4. To customize the default setpoint that appears in the appropriate box of the “Home” screen, tap in the entry
field, then use the keypad on the right to enter your default value.
The previous setting will be replaced immediately when you start entering digits on the keypad.
5. Tap Next on the keypad to continue to the next setpoint entry field.
If you have entered a correct speed value, the cursor will go to the next field.
If the centrifuge cannot be run with the setpoint you have just entered, an Out of range warning appears
beneath the setpoint entry field, as shown in the example
Figure 3–62 below. You will not be able to continue
until you have entered an acceptable setpoint value.
Figure 3–62: Settings -> Controls -> Setpoints Screen: Out of Range Value Alert
6. Tap the Save button to save the new setpoint(s).
A pop-up window appears, indicating that the setpoints have been successfully changed.
7. To confirm the changes, tap the OK button in the pop-up window that appears. Tapping the X icon closes
this window and exits without saving.
You will be returned to the “Controls” screen.
The new setpoints will now appear in the respective boxes of the “Home” screen.
Setpoints Mode
This button lets you choose whether you wish to run the centrifuge in standard (factory default) or advanced
setpoints mode. Standard mode allows you to run the centrifuge in a single timed mode only, while advanced
mode lets you choose which timed mode to run before starting the centrifuge.
Proceed as follows to toggle between Standard Mode and Advanced Mode:
1. Tap the Settings icon on the navigation bar.
2. Tap the Controls button on the “Settings” screen.
The “Controls” screen appears.
3. Tap the Setpoints Mode menu and choose “Advanced” to customize, or “Standard” to return to the factory
default.
4. Tap the Save button to save the new setpoints mode.
A pop-up window appears, indicating that the setpoints mode has been successfully changed.